This wonderful recipe creates a beautiful cheese that is full of flavor. Cabra Vino has a snow white paste that is very soft and supple with a few small gas holes distributed throughout. The rind has a deep purple hue and the taste and aroma from the wine is infused throughout the cheese.
-
Yield
3 Pounds
-
Aging Time
~2 Months
-
Skill Level
Intermediate
-
Author
Jim Wallace
Cabra al Vino Recipe
Ingredients
Total price for selected items: Total price:
Instructions
Acidify & Heat Milk
Begin by heating three gallons of a fresh goat's milk to 95°F (35°C). You do this by placing the milk in a pot or sink of very warm water. If you do this in a pot on the stove, make sure you heat the milk slowly and stir it well as it heats.
Once the milk is at 95°F, the culture can be added. To prevent the powder from caking and sinking in clumps, sprinkle the powder over the surface of the milk and then allow about 2 minutes for the powder to re-hydrate before stirring it in.
The milk needs to be maintained at 95°F for about 1 hour while the bacteria begin to work.
Note: If using pasteurized milk, the culture amount should be doubled.
Coagulate with Rennet
Once the milk has been ripened, add 1/8 tsp (~.6ml) of single strength liquid rennet. Stir in an even up and down motion for 1 minute.
Now the milk needs to sit still for 90 minutes while the culture works and the rennet coagulates the curd. The thermal mass of this milk should keep it warm during this period. It is OK if the temperature drops a few degrees during this time. You will notice the milk beginning to thicken in about 40-45 minutes, but let the milk set for a full 80-90 minutes for a firm curd.
Note: This is a low amount of rennet because the long coagulation time will allow the acid to work longer before the curd cutting and there is a very short cut/stir/cook time. This will allow for a moister curd and a proper level of acid as the curd is placed into the molds.
Cut & Cook Curds
Cut the curd vertically in both directions, at about 3/4-1/2 inch. Then let it rest 5 minutes.
The second cut will be horizontal with a spoon or flat ladle, and cut slowly to a pea to barley grain size, taking about 10 minutes.
See AlsoCanning Tomato Soup Recipe75 Free Canning Recipes for Beginning and Veteran Canners54 Summer Potluck Recipes to Feed a CrowdTart and Sweet: 101 Canning and Pickling Recipes for th…Allow the curd to settle and then remove 30% of the whey.
Then add back water @110F slowly to heat curds to 97°F over 10 minutes.
Stir for 30-40 minutes to achieve a moderately firm curd.
The final curds should be cooked well-through and should be examined to make sure that enough moisture has been removed. A broken curd should be firm throughout and the curds should have a moderate resistance when pressed between the fingers.
When this point is reached, the curds can be allowed to settle under the whey.
The photos above show the progression of curd firmness as they are gently stirred during the 30-40 minutes. It is very subtle, but the curds develop a more defined shape and firmness and they shrink in size.
Molding & Pressing
Two basket molds with cloths should have been sanitized earlier and can now be arranged on a draining surface but with no cloth at this point (the open basket design allows plenty of drainage).
Remove the whey down to just above the curd surface and then begin transferring the curds to the molds. Use moderate hand pressure for a firm pack into the molds.
Stack the 2 molds for a moderate amount of weight. I use a Stainless Follower Plate or the round disc from her Polypropylene Follower Set to separate the cheeses but any flat disc sized for the mold top will work.
Continue this for 30 minutes with no cloth and weight by simply reversing and re-stacking the molds after 15 minutes.
Molding & Pressing (cont.)
At 30 minutes, turn the cheese in the molds but with cloth.
Then, stack 2 high and weight at 5-7 lbs for 30 minutes. Turn in the molds and re-wrap in cloth using the same weight and time as above.
Keep warm at 75-80°F. I surround the press with a couple of pots or milk jugs of hot water and insulate with a thick towel. This is because the bacteria are still working and producing acid from the remaining lactose.
Next, the cheese is turned again in cloth, the molds stacked 2 high, and weighted at 15 lbs. Turn and re-wrap at 30 minute intervals for the next 4 hours.
The cheese has now been pressed for about 5 hours and should have reached its final acid level and moisture. If you have a pH meter, the final reading should be about 5.2. Remove the weights and you are now ready to salt the cheese in a brine bath.
Salting
Remove cheeses from cloth and they are ready to go into the brine at 52°F.
The final cheese weight here was 1.5 lbs each and the brine time was 5.5 hrs.You will need a saturated brine prepared for salting this cheese, find all of the details you need on brining here.
A simple brine formula is:
- 1 gallon of water
- 2.25 lbs of salt
- 1tbs. calcium chloride
- 1 tsp. white vinegar
- Bring the brine and cheese to 50-55°F before using.
The cheese will float above the brine surface, so sprinkle a small amount of salt on the top surface of the cheese. Flip the cheese and re-salt the surface about half way through the brine period.
At the end of the brine bath, wipe the surface dry and allow the cheese to surface dry for a day or two at 52°F and 85% moisture. The surface will darken somewhat during this time.
Soak in Wine
It is now time to finish the cheese in the traditional manner. By soaking the cheese in wine for several days, you will increase the surface acidity substantially and make it less hospitable for mold growth and hence less work in the aging space. I could have just used the entire bottle, but I have found that 2 of the cheeses fit nicely in a zip-lok bag and that less wine will do just fine to bathe the cheese when I squeeze out the excess air and zip the bag closed.
Before the wine soak, wash the surface in a light brine (1 tbs. salt in a cup of water) to remove any surface mold that developed and rehydrate the surface.
The 'Vino' I use for the bath is a very dark and aromatic wine from the Petit Sirah grape (nothing petite about this one though). Yes, this is one of my own wines, of course!
I have chosen to use less wine and used a 1 gallon zip-lok bag which just holds the 2 cheeses nicely. I can then use about 12-16 ozs. of wine and reward myself with the rest for all of my hard work here.
I pour the wine into the bag with the cheese and then squeeze as much of the air out as I can before sealing the bag.
If you feel less frugal, then you can use a pan or jar that just holds the 2 cheeses and fill the pot to cover the cheeses.
In either case, be sure to turn the cheese as often as possible so that the entire cheese absorbs the wine evenly.
I then aged the cheese in this bag in the aging room at 52°F for 36 hrs, turning several times.
Next, I removed the cheese from the bag, wiped the surface, and dried it off for 24 hours. This allowed the first dose of wine to migrate into the cheese before the second bath in wine.
Finally, I repeated the wine soak for another 48 hours, turning regularly.
Aging
The cheese is now ready for aging at 52-56°F and 80-85% moisture.
The cheese can now be aged for 4-6 weeks at which point, it will ready for your table.
You should see very little mold growth on the surface.
I find that a fine dusting of white mold shows up every 3 or so days and just needs a quick cloth wipe to remove.
Variation Without Wine
Cabra al Romero is made from the same recipe above but the cheese is coated with rosemary instead of wine following the traditional method used by a dairy in the Rufino region of Spain. The cheese is rolled in rosemary. This coat on the outside perfumes the cheese and imparts a gentle herbal aroma. It's a cheese of an extraordinary bouquet and unique creaminess. The Cabra al Romero is aged for a minimum of three months. The rosemary is left to flavor the rind, and permeate the cheese with its aromatics and subtle flavor. In the final days of aging, the cheese is brushed clean of mold and is rubbed with a lot of rosemary again.
Cheese Making Supplies
Popular Products
Cheese Making Recipes
Recommended Recipes
Beginner
30 Minute Mozzarella Recipe
3.2Learn how to make 30 Minute Mozzarella, in your own kitchen. With just a...
Beginner
30 Minute Mozzarella Recipe (no microwave)
4.1Make 30 Minute Mozzarella right at home with a simple water batch method...
Advanced
Alpine Style Cheese Making Recipe
This wonderful recipe goes above and beyond traditional Alpine style che...
Intermediate
Alpine Tomme Recipe
4.8This recipes focus is on making an Alpine style cheese, but not followin...
Advanced
Alpine Washed Rind Cheese Making Recipe
5.0This Washed Rind Alpine Cheese recipe is based on an alpine style cheese...
Advanced
Appenzeller Cheese Making Recipe
5.0This is a recipe for making an Appenzeller style cheese. Since we don't ...
Intermediate
Asiago Cheese Recipe
4.7This recipe for fresh Asiago dolce or fresco, also known as Pressato is ...
Advanced
Beaufort Cheese Making Recipe
Beaufort cheese is produced in the Tarentaise mountains surrounding Mt. ...
Intermediate
Beer Infused Cheese Recipe
4.9This cheese making recipe combines beer and cheese together. The result...
Intermediate
Bel Paese Recipe
5.0Bel Paese is a very fresh cheese that goes well with everything. Loved b...
Aging
How to Make a Cheese Cave
Learn how to make a cheese cave right at home. If you want your cheese to ripen properly you have to make them a good home and take care of them like little bambinos.
Join the Cheese Making Club!
Sign up and be the first to know about new recipes, products, and lots of other fun updates.